Chapter 2 Web Configurator
NR2101 User’s Guide
38
Add Entry IP Family
Use this field to select IPv4 or IPv6.
IPv4 Source
Address
Use this field to enter the source device’s IPv4 address.
IPv4 Source
Subnet mask
Use this field to enter the IPv4 source subnet mask.
IPv6 Address
Use this field to enter the source device’s IPv6 address.
IPv6 Prefix Length
Use this field to enter the address prefix length.
Protocol Use this field to select the protocol used to transport packets.
LAN SETTINGS LAN Gateway IP Use this field to view the LAN IP address.
LAN Subnet Mask Use this field to view the subnet mask.
LAN DHCP Use this field to enable or disable the NR2101’s DHCP server.
LAN DHCP Start IP This field specifies the first of the contiguous addresses in the IP address
pool for LAN.
LAN DHCP End IP This field specifies the last of the contiguous addresses in the IP address
pool for LAN.
LAN DHCP Lease
Time
This is the period of time DHCP-assigned addresses is used.
SMS Serial No. Use this field to view the entry number of the SMS messages stored on
the NR2101.
From Use this field to view the telephone number of the sender.
Date/Time Use this field to view the time and date of the SMS messages stored on
the NR2101.
Content Use this field to view the content of the SMS messages.
Send to Use this field to enter the phone number of the message receiver.
FIRMWARE
UPGRADE
Current Version Use this field to view the current firmware version of the NR2101.
ACCOUNT
CONFIGURATION
Session Timeout
(Min)
Use this field to edit the setting of session timeout.
Old Password Use this field to change the password entering the old password.
New Password Use this field to enter a new password of 4 to 20 characters. The new
password must contain one numeric, one lowercase, one upper case
letter and one special character.
Confirm New
Password
Retype the new password again to confirm the change.
ABOUT Software version Use this field to view the current software version of the NR2101.
MiFi Software
version
Use this field to view the current MiFi software version of the NR2101.
Zyxel Firmware
version
Use this field to view the current firmware version of the NR2101.
FACTORY RESET Use this field to restore the NR2101 back to the factory default mode.
LOGOUT Use this field to log out of the NR2101’s web configurator.
Table 17 Navigation Panel Summary (continued)
LINK TAB DESCRIPTION
To Next Page
Loading...
