Chapter 1 Getting to Know Your NSA
NSA221 User’s Guide
24
1.3.1 COPY/SYNC Button
Use the COPY/SYNC button on the front panel to copy or synchronize files
between a connected USB device and the NSA. See Section 9.10 on page 204 for
more details on how to configure the copy/sync settings.
1.3.2 RESET Button
Use the RESET button on the rear panel to restore the NSA’s default settings.
Figure 3 The RESET Button
•Press the RESET button until you hear one beep (after about two seconds),
then release it. You will hear one more beep after you release the button.
This resets the NSA’s IP address and password to the default values.
LAN Green On The NSA has a successful 10/100 Mbps Ethernet
connection.
Blinking The 100M LAN is sending or receiving packets.
Off The NSA does not have a 10/100 Mbps Ethernet
connection.
Amber On The NSA has a successful 1000 Mbps Ethernet
connection.
Blinking The 1000 M LAN is sending or receiving packets.
Off The NSA does not have a 1000 Mbps Ethernet
connection.
COPY/
SYNC
Green On A USB device is connected to the NSA.
Blinking The NSA is copying or synchronizing files to or from the
USB device.
Red On Copying or synchronizing files to or from the USB device
failed.
Off No USB device is connected.
Table 1 LEDs (continued)
LED COLOR STATUS DESCRIPTION
Press
1 Beep
2 Beeps
IP Address
Password
Clear All Settings
5 more seconds
Release to
Release to Reset
To Next Page
Loading...
