ZyXEL Communications NSA221 - Configure Network Setting

Chapter 2 NAS Starter Utility
NSA221 User’s Guide
44
2.9 Configure Network Setting
Use these screens to change the NSA network settings such as the NSA’s name, IP
address, subnet mask, default gateway, DNS, or PPPoE.
Click Configure network setting in the main utility screen to display the
following screen.
Figure 34 NAS Starter Utility > Configure network setting
The following table describes the labels in this screen.
Table 5 NAS Starter Utility > Config
LABEL DESCRIPTION
NAS Name Specify a name to uniquely identify the NSA on your network. You can
enter up to 15 alphanumeric characters with minus signs allowed but
not as the last character. The name must begin with an alphabetic
character (a-z) and is NOT case sensitive.
Get IP
automatically
from DHCP
server
Select this if the NSA is automatically assigned an IP address from the
ISP or a DHCP server in your network.
Assign IP
Manually
Select this if you want to assign the NSA a fixed IP address, subnet
mask and default gateway.
Note: Do not configure an IP address that is already in use in your
network. This results to a network IP address conflict and
makes the NSA inaccessible.
Use DNS server
from DHCP
server
Domain Name System (DNS) is for mapping a domain name to its
corresponding IP address and vice versa. Select this if the NSA is
automatically given DNS information from the ISP or a DHCP server in
your network.