Chapter 15 Static Route
P-79X Series User’s Guide
159
Figure 96 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 63 Advanced > Static Route: Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Route Name Enter the name of the IP static route. The text may consist of up to 9 letters,
numerals and any printable character found on a typical English language
keyboard. Leave this field blank to delete this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway Type Use either Gateway Address or Gateway Node to configure a static route.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
Gateway Node This field is available when you select Gateway Node from Gateway Type.
Select a remote node to set the static route. A remote note is a connection point
outside of the local area network. One example of a remote node is your
connection to your ISP.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
