Chapter 6 WAN Setup
P-79X Series User’s Guide
51
6.2.2 Advanced Internet Access Setup
Use this screen to edit your P-79X's advanced WAN settings. Click the Advanced Setup button in
the Internet Access Setup screen. The screen appears as shown.
Figure 30 Network > WAN > Internet Access Setup: Advanced Setup
Enable Rate
Adaption
Indicate whether or not the P-79X can adjust the speed of its connection to
that of the other device.
Transfer Max Rate
(Kbps)
This field is enabled if Service Type is Server. Set the maximum rate at which
the P-79X sends and receives information. The actual transfer rate will be
between this value and the minimum transfer rate you configure.
Transfer Min Rate
(Kbps)
This field is enabled if Service Type is Server. Set the minimum rate at which
the P-79X sends and receives information. The actual transfer rate will be
between this value and the maximum transfer rate you configure.
Standard Mode
Select the operational mode the P-79X uses in the DSL connection. Annex A
refers to connections over POTS and Annex B refers to connections over ISDN
lines.
Modulation
Select the modulation supported by your ISP.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
Advanced Setup Click this button to display the Advanced WAN Setup screen and edit more
details of your WAN setup.
Table 14 2wire-2line Service Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
