Chapter 22 Logs
P-79X Series User’s Guide
207
Figure 122 Maintenance > Logs > View Log
The following table describes the fields in this screen.
22.3 The Log Settings Screen
Use the Log Settings screen to configure the mail server, the syslog server, when to send logs and
what logs to send.
To change your P-79X’s log settings, click Maintenance > Logs > Log Settings. The screen
appears as shown.
Alerts are e-mailed as soon as they happen. Logs may be e-mailed as soon as the log is full.
Selecting many alert and/or log categories (especially Access Control) may result in many e-mails
being sent.
Table 84 Maintenance > Logs > View Log
LABEL DESCRIPTION
Display The categories that you select in the Log Settings screen display in the drop-
down list box.
Select a category of logs to view; select All Logs to view logs from all of the log
categories that you selected in the Log Settings page.
Email Log Now Click this to send the log screen to the e-mail address specified in the Log
Settings page (make sure that you have first filled in the E-mail Log Settings
fields in Log Settings).
Refresh Click this to renew the log screen.
Clear Log Click this to delete all the logs.
# This field is a sequential value and is not associated with a specific entry.
Time This field displays the time the log was recorded.
Message This field states the reason for the log.
Source This field lists the source IP address and the port number of the incoming packet.
Destination This field lists the destination IP address and the port number of the incoming
packet.
Notes This field displays additional information about the log entry.
To Next Page
Loading...
