Chapter 19 Remote Management
P-79X Series User’s Guide
188
19.6 The DNS Screen
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice
versa. Refer to Chapter 8 on page 74 for background information.
Use this screen to set from which IP address the P-79X will accept DNS queries and on which
interface it can send them your P-79X’s DNS settings. This feature is not available when the P-79X
is set to bridge mode. Click Advanced > Remote MGMT > DNS to change your P-79X’s DNS
settings.
Figure 116 Advanced > Remote MGMT > DNS
Access Status Select the interface(s) through which a computer may access the P-79X using
this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with
the P-79X using this service.
Select All to allow any computer to access the P-79X using this service.
Choose Selected to just allow the computer with the IP address that you
specify to access the P-79X using this service.
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community Enter the Set community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
TrapCommunity Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
TrapDestination Type the IP address of the station to send your SNMP traps to.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 77 Advanced > Remote MGMT > SNMP
LABEL DESCRIPTION
To Next Page
Loading...
