ZyXEL Communications P-793H v3 - Set up the Client

Chapter 5 Tutorials
P-79X Series User’s Guide
39
2 Click Network > WAN > Internet Access Setup.
3 Configure the Internet Access Setup screen as the following. Select ATM as the Transfer Mode.
Select Bridge as the Mode. Configure the Multiplexing, Encapsulation, VPI, and VCI fields for
the point-to-point connection. Select 1 in the Line field as the DSL line you want the P-79X to use
as a default for outgoing traffic.
4 Then configure the Service Type section. Select 2 wire in the Service Mode field. In the Service
Type field, select Server. Select 5696 as the Transfer Max Rate and 3200 as the Transfer Min
Rate. Leave the rest of the fields set to their default settings. Click Apply.
Figure 23 WAN > Internet Access Setup
5.2.2 Set Up the Client
1 Log in to the client P-79X of branch office B.
2 Click Network > WAN > Internet Access Setup.
3 Select ATM as the Transfer Mode. Select Bridge as the Mode. Set the Multiplexing,
Encapsulation, VPI, and VCI to the same values you set in the server. Select 1 in the Line field
as the DSL line you want the P-79X to use as a default for outgoing traffic.