Chapter 8 LAN Setup
P-79X Series User’s Guide
78
8.3 The DHCP Setup Screen
Use this screen to configure the DNS server information that the P-79X sends to the DHCP client
devices on the LAN. Click Network > DHCP Setup to open this screen.
Allow between LAN
and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default policy
set to block WAN to LAN traffic, you also need to enable the default WAN to
LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Packet Filter
Incoming Filter Sets
Protocol Filter Select the protocol filter(s) to control incoming traffic. You may choose up to 4
sets of filters.
You can configure packet filters in the Packet Filter screen. See Chapter 12
on page 119 for more details.
Generic Filter Select the generic filter(s) to control incoming traffic. You may choose up to 4
sets of filters.
You can configure generic filters in the Packet Filter screen. See Chapter 12
on page 119 for more details.
Outgoing Filter Sets
Protocol Filter Select the protocol filter(s) to control outgoing traffic. You may choose up to 4
sets of filters.
You can configure protocol filters in the Packet Filter screen. See Chapter 12
on page 119 for more details.
Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose up to 4
sets of filters.
You can configure generic filters in the Packet Filter screen. See Chapter 12
on page 119 for more details.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 23 Network > LAN > IP: Advanced Setup
LABEL DESCRIPTION
To Next Page
Loading...
