Chapter 4 Internet Setup Wizard
P-79X Series User’s Guide
34
Figure 19 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 10 Internet Access Wizard Setup: ISP Parameters
LABEL DESCRIPTION
Transfer Mode Select the transfer mode you want to use.
PTM (Packet Transfer Mode): The P-79X uses the SHDSL technology for data
transmission over the DSL port.
ATM (Asynchronous Transfer Mode): The P-79X uses the ADSL technology for data
transmission over the DSL port.
Select Auto if the P-79X uses the SHDSL or the ADSL technology for data
transmission over the DSL port.
Mode Select Routing (default) from the drop-down list box if your ISP give you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly.
If you select Bridge, you cannot use Firewall, DHCP server and NAT on the P-79X.
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down
list box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select RFC 1483.
If you select Routing in the Mode field, select RFC 1483 or PPPoE.
To Next Page
Loading...
