Chapter 6 WAN Setup
P-79X Series User’s Guide
54
Figure 32 Network > WAN > More Connections: Edit
The following table describes the labels in this screen.
Table 17 Network > WAN > More Connections: Edit
LABEL DESCRIPTION
# This is the index number of the WAN connections.
General
Active Select the check box to activate or clear the check box to deactivate this
connection.
Name Enter a unique, descriptive name of up to 13 ASCII characters for this
connection.
Mode Select Routing from the drop-down list box if your ISP allows multiple
computers to share an Internet account.
If you select Bridge, the P-79X will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down
list box. Choices vary depending on the mode you select in the Mode
field.
If you select Bridge in the Mode field, select ENET ENCAP.
If you select Routing in the Mode field, select ENET ENCAP or PPPoE.
If you set up a point-to-point connection, select ENET ENCAP.
User Name (PPPoE encapsulation only) Enter the user name exactly as your ISP
assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.
Password (PPPoE encapsulation only) Enter the password associated with the user
name above.
Enter 802.1P Priority[0-
7]
Specify a priority level (between 0 and 7). "0" is the lowest priority level
and "7" is the highest.
To Next Page
Loading...
