Chapter 5 The Configuration Utility
PLA-401 v3 User’s Guide
37
5.3 Configuration Screen
Use the Configuration screen to see which devices are recognized by your
powerline network, to configure your PLA-401 v3 and to set up a secure powerline
network by changing the powerline network name. This screen opens up when you
launch the utility.
Note: Use the icon to view online help information in each screen of the utility.
Figure 15 Configuration Screen
The following table describes the labels in this screen.
Table 4 Configuration Screen
LABEL DESCRIPTION
Network
Topology
Use this to select which powerline network information is displayed.
Different powerline networks are identified by the Ethernet interface
(network card) connected directly to the PLA-401 v3. Typically there is
only one connection, however, if your computer has two network cards and
both are connected to a powerline device then you have two powerline
networks.
The fields described below are used to identify the powerline adapters recognized on the
powerline network. The configuration utility automatically updates this information every
10 seconds. Click Scan to refresh the information in these fields (immediately).
Note: Only devices which share the same network name are displayed in this table.
To Next Page
Loading...
