Chapter 5 The Configuration Utility
PLA-401 v3 User’s Guide
44
The following table describes the labels in this screen.
5.7 About Screen
Use the About screen to view information regarding the configuration utility and
firmware version of the PLA-401 v3 you are connected to. Click the icon in the
top right corner of the utility to view the About screen.
Figure 20 About Screen
Table 7 Advanced Screen
LABEL DESCRIPTION
Adapter This field identifies which powerline network information is displayed.
Different powerline networks are identified by the Ethernet interface
(network card) on your computer which is connected directly to a
powerline adapter. Typically there is only one connection. However, if your
computer has two network cards and both are connected to a powerline
adapter, then you have two powerline networks.
Site This field displays:
• Local, if it is the PLA-401 v3 directly connected to the computer
running the configuration utility.
• Remote, if it is a powerline adapter in your powerline network but not
directly connected to the computer running the configuration utility.
MAC
Address
This is a read-only field which shows the MAC address of the powerline
adapter you are configuring. You can find the MAC address of your PLA-401
v3 displayed on a sticker on the bottom of your device.
Priority Select a priority setting from the drop-down box for traffic FROM your
selected device. The options, in order of importance, are High, Medium,
Normal and Low.
Save Click this to apply your changes. The new Priority setting is applied to the
selected powerline adapter.
Upgrade to
latest version
firmware and
utility.
To Next Page
Loading...
