PLA-401 v3 User’s Guide
81
APPENDIX A
Product Specifications
The following tables summarize the PLA-401 v3’s hardware and firmware features.
Table 15 Hardware Specifications
Dimensions (W x D x
H)
95 mm (L) x 65 (H) mm x 80 (W) mm
Power Input 100 - 240 VAC, 50/60 Hz, 0.12 A
Ethernet Port Auto-negotiating: 10 Mbps or 100 Mbps in either half-duplex or
full-duplex mode.
Auto-crossover: Use either crossover or straight-through Ethernet
cables.
RESET Pressing this button in for less than 3 seconds resets the device to
factory default settings. Network Name becomes HomePlugAV.
ENCRYPT Pressing this button in for less than 3 seconds begins the
connection setup process.
Pressing this button in for more than 10 seconds resets the
network name to a random value.
Operation
Environment
Temperature: 0º C ~ 45º C
Humidity: 20% ~ 90% Noncondensing
Storage Environment Temperature: -20º C ~ 70º C
Humidity: 20% ~ 95% Noncondensing
Cabling Type 1 x LAN UTP Category 5 or Better
Network Interface 1 x 10/100M BASE-T Ethernet port with Auto MDI/MDIX
Distance between the
centers of the holes
on the device’s back.
74 mm
Recommended type
of screws for wall-
mounting
Not applicable
To Next Page
Loading...
