Chapter 7 Powerline Network Setup Tutorial
PLA-401 v3 User’s Guide
68
2 The utility should open to the configuration tab as shown below. A list of powerline
adapters on your network displays. These adapters all have the same network
name as the adapter you are connected to. The adapter you are connected to will
appear as Local in this table. All others are listed as Remote.
Figure 43 Local/Remote Adapters on a Powerline Network
3 To set up a new powerline network, type the DAK Password and change the
Network Name on all powerline adapters you wish to add to your network.
• Look for the DAK Password on a label on your powerline adapter. The
DAK Password lets you access the adapter.
• Select the Remote adapter you want to add (A) and type the DAK
Password in the DAK Password field (B).
• Then type the new network name in the Network Name field.
Figure 44 Adding an Adapter to Your New Network
B
A
To Next Page
Loading...
