Chapter 8 LEDs and Troubleshooting
PLA-401 v3 User’s Guide
77
The POWER lights on both devices blink, then many lights blink and the
HomePlug light blinks red.
Do not worry, the connection process is proceeding normally.
The POWER lights on both devices finished blinking, but only one device’s
HomePlug light is on.
One device may have connected to a third powerline device. To check device A is
connected to device B and not another device, disconnect device B from its power
source. Device A’s HomePlug ( ) light will turn off if the connection is with Device
B. Press the ENCRYPT button on both devices for more than 10 seconds, then try
to reconnect, pressing the ENCRYPT button for less than 3 seconds on both
devices.
I pressed the ENCRYPT button for more than 10 seconds, but the HomePlug light
is still on.
The HomePlug light is on, indicating it is still connected to another powerline
device. Try again, pressing the ENCRYPT button for more than 10 seconds.
To Next Page
Loading...
