Chapter 2 Hardware
PM7300-T0 User’s Guide
12
2.1.2 Panel Ports & Buttons
Figure 3 Side Panel
The following table describes the items on the rear panel.
2.1.3 RESET Button
Insert a thin object into the RESET hole of the PM7300-T0 to reload the factory-default configuration file if
you forget your password or IP address, or you cannot access the Web Configurator. This means that
you will lose all configurations that you had previously saved. The password will be reset to the default
(see the PM7300-T0 label) and the IP address will be reset to 192.168.0.1.
PON Green On The PON connection is ready.
Blinking The PM7300-T0 is trying to establish a link.
Off The fiber link is down.
LOS Red On PON transceiver is powered down.
Blinking This is a R(x) low power alarm.
Off The PON connection is working normally.
10GbE Green On The Ethernet link is up.
Blinking The PM7300-T0 is transmitting or receiving data.
Off The Ethernet link is down.
Table 2 PM7300-T0 LED Behavior (continued)
LED COLOR STATUS DESCRIPTION
Table 3 Panel Ports and Buttons
LABELS DESCRIPTION
RESET Press for 5 seconds to restore the PM7300-T0 to its factory default settings.
PON Connect the PM7300-T0 to the Internet using a fiber cable.
10GbE Connect the PM7300-T0 to an Ethernet device such as a network switch, NAS or server. Connect a
computer for initial configuration.
POWER Connect the power adapter and press the POWER button to start the PM7300-T0.
ON/OFF Press the ON/OFF button after connecting the power adapter to start the PM7300-T0.
To Next Page
Loading...
