PM7300-T0 User’s Guide
47
CHAPTER 14
Firmware Upgrade
14.1 Overview
This chapter explains how to upload new firmware to your PM7300-T0. You can download new firmware
releases from your nearest Zyxel FTP site (or www.zyxel.com) to use to upgrade your device’s
performance.
Only use firmware for your device’s specific model. Refer to the label on
the bottom of your PM7300-T0.
14.2 The Firmware Screen
Click Maintenance > Firmware Upgrade to open the following screen. The upload process uses HTTP
(Hypertext Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot.
Do NOT turn off the PM7300-T0 while firmware upload is in progress.
Figure 32 Maintenance > Firmware Upgrade
To Next Page
Loading...
