Chapter 11 User Account
PM7300-T0 User’s Guide
42
The following table describes the labels on this screen.
11.2.1 The User Account Add/Edit Screen
Click Add New Account or the Modify icon of an existing account in the Maintenance > User Account to
open the following screen.
System Monitor
Log Yes Yes
Traffic Status Yes Yes
Maintenance
System Yes No
User Account Yes Yes
Remote Management Yes Yes
Log Setting Yes Yes
Firmware Upgrade Yes Yes
Backup Restore Yes Yes
Reboot Yes Yes
Table 21 Maintenance > User Account
LABEL DESCRIPTION
Add New
Account
Click this button to add a new user account.
# This is the index number
Active This field indicates whether the user account is active or not.
Clear the check box to disable the user account. Select the check box to enable it.
User Name This field displays the name of the account used to log into the PM7300-T0 Web Configurator.
Retry Times This field displays the number of times consecutive wrong passwords can be entered for this
account. 0 means there is no limit.
Idle Timeout This field displays the length of inactive time before the PM7300-T0 will automatically log the user
out of the Web Configurator.
Lock Period This field displays the length of time a user must wait before attempting to log in again after a
number of consecutive wrong passwords have been entered as defined in Retry Times.
Group This field displays whether this user has Administrator or User privileges.
Modify Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Apply Click Apply to save your changes back to the PM7300-T0.
Cancel Click Cancel to restore your previously saved settings.
Table 20 Administrator/User privilege differences
LINK TAB ADMINISTRATOR USER
To Next Page
Loading...
