Chapter 11 User Account
PM7300-T0 User’s Guide
43
Figure 29 Maintenance > User Account > Edit
The following table describes the labels on this screen.
Table 22 Maintenance > User Account > Add/Edit
LABEL DESCRIPTION
Active Click to enable (switch turns blue) or disable (switch turns gray) the user account. This field is
grayed out if you are editing the logged-in account.
User Name Enter a new name for the account (up to 15 characters). Special characters are allowed except
the following: double quote (") back quote (`) apostrophe or single quote (') less than (<) greater
than (>) caret or circumflex accent (^) dollar sign ($) vertical bar (|) ampersand (&) semicolon
(;)
Old Password Type the default password or the existing password used to access the PM7300-T0 Web
Configurator. This field only appears when editing an existing account.
New Password Type your new system password (up to 256 characters). Note that as you type a password, the
screen displays a (*) for each character you type. Click the eye icon to view the password. After
you change the password, use the new password to access the PM7300-T0.
Verify Password Type the new password again for confirmation. Click the eye icon to view the password.
Retry Times Enter the number of times consecutive wrong passwords can be entered for this account. 0
means there is no limit.
Idle Timeout Enter the length of inactive time before the PM7300-T0 will automatically log the user out of the
Web Configurator.
Lock Period Enter the length of time a user must wait before attempting to log in again after a number of
consecutive wrong passwords have been entered as defined in Retry Times.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
