Chapter 5 Broadband
PM7300-T0 User’s Guide
25
Figure 16 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
The following table describes the fields in this screen.
Table 8 Network Setting > Broadband > Add/Edit New WAN Interface (Bridge Mode)
LABEL DESCRIPTION
General Click this switch to enable or disable the interface. When the switch goes to the right , the
function is enabled. Otherwise, it is not.
Name Enter a service name of the connection.
This field is read-only is you are editing the WAN interface.
Type This field shows a GPON connection.
This field is read-only is you are editing the WAN interface.
Mode Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP’s DHCP server directly.
VLAN Click this switch to enable or disable VLAN on this WAN interface. When the switch goes to the right
, the function is enabled. Otherwise, it is not.
802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Cancel Click Cancel to exit this screen without saving any changes.
Apply Click Apply to save your changes.
To Next Page
Loading...
