Chapter 6 Home Networking
PM7300-T0 User’s Guide
27
3 Click Apply to save your settings.
Figure 17 Network Setting > Home Networking
The following table describes the fields on this screen.
Table 9 Network Setting > Home Networking
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IPv4 address you want to assign to your PM7300-T0 in dotted decimal notation, for
example, 192.168.0.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your PM7300-T0 automatically computes the subnet mask based on the IP
Address you enter, so do not change this field unless you are instructed to do so.
Apply
Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
