Chapter 7 Monitor
ZyWALL/USG Series User’s Guide
230
7.26.2 View AP Log
Click on Monitor > Log > View AP Log to open the following screen.
Message This field displays the reason the log message was generated. The text “[count=x]”,
where x is a number, appears at the end of the Message field if log consolidation is
turned on and multiple entries were aggregated to generate into this one.
Source Address This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
Destination Address This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in
this filter.
Source Interface This displays when you show the filter. Type the source interface of the incoming
packet that generated the log message.
Destination Interface This displays when you show the filter. Type the interface of the destination of the
incoming packet when the log message was generated.
Protocol This displays when you show the filter. Select a service protocol whose log
messages you would like to see.
Search This displays when you show the filter. Click this button to update the log using the
current filter settings.
Email Log Now Click this button to send log message(s) to the Active e-mail address(es) specified
in the Send Log To field on the Log Settings page.
Refresh Click this button to update the information in the screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on
the screen.
# This field is a sequential value, and it is not associated with a specific log message.
Time This field displays the time the log message was recorded.
Priority This field displays the priority of the log message. It has the same range of values
as the Priority field above.
Source This field displays the source IP address and the port number in the event that
generated the log message.
Destination This field displays the destination IP address and the port number of the event that
generated the log message.
Note This field displays any additional information about the log message.
Table 78 Monitor > Log > View Log (continued)
LABEL DESCRIPTION
To Next Page
Loading...
