Chapter 10 Interfaces
ZyWALL/USG Series User’s Guide
291
10.4.2 PPP Interface Add or Edit
Note: You have to set up an ISP account before you create a PPPoE/PPTP/L2TP interface.
This screen lets you configure a PPPoE or PPTP or L2TP interface. If you enabled IPv6 in the
Configuration > System > IPv6 screen, you can also configure PPP interfaces used for your IPv6
networks on this screen. To access this screen, click the Add icon or an Edit icon in the PPP
Interface screen.
Connect To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP
interface.
Disconnect To disconnect an interface, select it and click Disconnect. You might use this in testing
the interface.
Object References Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See Section 10.3.4 on page 286 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry
is inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
Name This field displays the name of the interface.
Base Interface This field displays the interface on the top of which the PPPoE/PPTP/L2TP
interface is.
Account Profile This field displays the ISP account used by this PPPoE/PPTP interface.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Table 105 Configuration > Network > Interface > PPP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
