Chapter 28 Security Policy
ZyWALL/USG Series User’s Guide
529
28.6 The Session Control Screen
Click Configuration > Security Policy > Session Control to display the Security Policy
Session Control screen. Use this screen to limit the number of concurrent NAT/Security Policy
sessions a client can use. You can apply a default limit for all users and individual limits for specific
users, addresses, or both. The individual limit takes priority if you apply both.
Figure 368 Configuration > Security Policy > Session Control
Name This is the name of the anomaly policy. Click the Name column heading to sort
in ascending or descending order according to the protocol anomaly policy
name.
Log These are the log options. To edit this, select an item and use the Log icon.
Action This is the action the ZyWALL/USG should take when a packet matches a policy.
To edit this, select an item and use the Action icon.
OK Click OK to save your settings to the ZyWALL/USG, complete the profile and
return to the profile summary page.
Cancel Click Cancel to return to the profile summary page without saving any changes.
Save Click Save to save the configuration to the ZyWALL/USG but remain in the same
page. You may then go to the another profile screen (tab) in order to complete
the profile. Click OK in the final profile screen to complete the profile.
Table 201 Configuration > Security Policy > ADP > Profile > Add-Protocol-Anomaly
LABEL DESCRIPTION
To Next Page
Loading...
