Chapter 43 System
ZyWALL/USG Series User’s Guide
873
43.14 Language Screen
Click Configuration > System > Language to open the following screen. Use this screen to
select a display language for the ZyWALL/USG’s Web Configurator screens.
Figure 619 Configuration > System > Language
The following table describes the labels in this screen.
43.15 IPv6 Screen
Click Configuration > System > IPv6 to open the following screen. Use this screen to enable
IPv6 support for the ZyWALL/USG’s Web Configurator screens.
Figure 620 Configuration > System > IPv6
The following table describes the labels in this screen.
Table 368 Configuration > System > Language
LABEL DESCRIPTION
Language Setting Select a display language for the ZyWALL/USG’s Web Configurator screens. You also
need to open a new browser session to display the screens in the new language.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Table 369 Configuration > System > IPv6
LABEL DESCRIPTION
Enable IPv6 Select this to have the ZyWALL/USG support IPv6 and make IPv6 settings be
available on the screens that the functions support, such as the Configuration >
Network > Interface > Ethernet, VLAN, and Bridge screens. The ZyWALL/USG
discards all IPv6 packets if you clear this check box.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
