ZyXEL Communications USG40 - 42.3.2.3 Security List

Chapter 42 Object
ZyWALL/USG Series User’s Guide
749
42.3.2.3 Security List
This screen allows you to manage wireless security configurations that can be used by your SSIDs.
Wireless security is implemented strictly between the AP broadcasting the SSID and the stations
that are connected to it.
To access this screen click Configuration > Object > AP Profile > SSID > Security List.
Note: You can have a maximum of 32 security profiles on the ZyWALL/USG.
Figure 510 Configuration > Object > AP Profile > SSID > Security List
Band Select: To improve network performance and avoid interference in the 2.4 GHz frequency band,
you can enable this feature to use the 5 GHz band first. You should set 2.4GHz and 5 GHz
radio profiles to use the same SSID and security settings.
Select standard to have the AP try to connect the wireless clients to the same SSID using
the 5 GHZ band. Connections to an SSID using the 2.4GHz band are still allowed.
Otherwise, select disable to turn off this feature.
VLAN ID Enter the VLAN ID that will be used to tag all traffic originating from this SSID if the VLAN
is different from the native VLAN.
Hidden SSID Select this if you want to “hide” your SSID from wireless clients. This tells any wireless
clients in the vicinity of the AP using this SSID profile not to display its SSID name as a
potential connection. Not all wireless clients respect this flag and display it anyway.
When an SSID is “hidden” and a wireless client cannot see it, the only way you can connect
to the SSID is by manually entering the SSID name in your wireless connection setup
screen(s) (these vary by client, client connectivity software, and operating system).
Enable Intra-BSS
Traffic Blocking
Select this option to prevent crossover traffic from within the same SSID.
Local VAP
Setting
This part of the screen only applies to ZyWALL/USG models that have built-in wireless
functionality (AP) - see Table 1 on page 25.
VLAN Support Select On to have the ZyWALL/USG assign the VLAN ID listed in the top part of the screen
to the built-in AP.
Select Off to have the ZyWALL/USG ignore the VLAN ID listed in the top part of the screen.
Select an Outgoing Interface to have the ZyWALL/USG assign an IP address in the same
subnet as the selected interface to the built-in AP.
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving your changes.
Table 294 Configuration > Object > AP Profile > SSID > Add/Edit SSID Profile (continued)
LABEL DESCRIPTION