ZyXEL Communications VMG4005-B50B - Page 12

Chapter 1 VMG Introduction
VMG4005-B50B User’s Guide
12
Figure 5 Distance Between Holes
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the VMG with the connection
cables.
5 Align the holes on the back of the VMG with the screws on the wall. Hang the VMG on the screws.
Figure 6 Wall Mounting Example