Chapter 4 Home Networking
VMG4005-B50B User’s Guide
23
3 Click Apply to save your settings.
Figure 11 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
4.3 UPnP
Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for simple
peer-to-peer network connectivity between devices. A UPnP device can dynamically join a network,
obtain an IP address, convey its capabilities and learn about other devices on the network. In turn, a
device can leave a network smoothly and automatically when it is no longer in use.
See page 21 for more information on UPnP.
Table 6 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See Chapter 15
on page 178 for how to create a new interface group.
LAN IP Setup
IP Address Enter the LAN IPv4 address you want to assign to your VMG in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your VMG automatically computes the subnet mask based on the IP address
you enter, so do not change this field unless you are instructed to do so.
Apply
Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
