Chapter 10 Remote Management
VMG4005-B50B User’s Guide
43
10.3.1 Add Trust Domain
Use this screen to configure a public IP address which is allowed to access the VMG. Click the Add Trust
Domain button in the Maintenance > Remote Management > Trust Domain screen to open the following
screen.
Figure 22 Maintenance > Remote Management > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trust IP address.
Table 17 Maintenance > Remote Management > Trust Domain (continued)
LABEL DESCRIPTION
Table 18 Maintenance > Remote Management > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Address
Enter a public IPv4 IP address which is allowed to access the service on the VMG from the WAN.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
