Chapter 9 User Account
VMG4005-B50B User’s Guide
39
9.2.1 User Account Add/Edit
Click Add New Account or the Edit icon of an existing account in the Maintenance > User Account to
open the following screen.
Figure 19 Maintenance > User Account > Add/Edit
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.
Table 14 Maintenance > User Account (continued)
LABEL DESCRIPTION
Table 15 Maintenance > User Account > Add/Edit
LABEL DESCRIPTION
Active Select Enable or Disable to activate or deactivate the user account.
User Name Enter a new name for the account. This field displays the name of an existing account.
Old Password Type the default password or the existing password used to access the VMG Web Configurator.
Password/New
Password
Type your new system password (up to 256 characters). Note that as you type a password, the
screen displays a (*) for each character you type. After you change the password, use the new
password to access the VMG.
Verify Password/
Verify New
Password
Type the new password again for confirmation.
Retry Times Enter the number of times consecutive wrong passwords can be entered for this account. 0
means there is no limit.
Idle Timeout Enter the length of inactive time before the VMG will automatically log the user out of the Web
Configurator.
Lock Period Enter the length of time a user must wait before attempting to log in again after a number if
consecutive wrong passwords have been entered as defined in Retry Times.
Group Specify whether this user will have Administrator or User privileges.
To Next Page
Loading...
