Chapter 24 Multicast
XGS2210 Series User’s Guide
227
24.2 Multicast Setup
Use this screen to configure IGMP for IPv4 or MLD for IPv6 and set up multicast VLANs. Click Advanced
Application > Multicast in the navigation panel.
Figure 169 Advanced Application > Multicast Setup
The following table describes the labels in this screen.
24.3 IPv4 Multicast Status
Click Advanced Application > Multicast > IPv4 Multicast to display the screen as shown. This screen
shows the IPv4 multicast group information. See Section 24.1 on page 223 for more information on
multicasting.
Figure 170 Advanced Application > Multicast > IPv4 Multicast
The following table describes the labels in this screen.
24.3.1 IGMP Snooping
Click the IGMP Snooping link in the Advanced Application > Multicast > IPv4 Multicast screen to display
the screen as shown. See Section 24.1 on page 223 for more information on multicasting.
Table 88 Advanced Application > Multicast Setup
LABEL DESCRIPTION
IPv4 Multicast Click the link to open screens where you can configure IGMP snooping and IGMP filtering for
IPv4.
IPv6 Multicast Click the link to open screens where you can configure MLD snooping-proxy and MLD filtering
for IPv6.
MVR Click the link to open screens where you can create multicast VLANs.
Table 89 Advanced Application > Multicast > IPv4 Multicast
LABEL DESCRIPTION
Index This is the index number of the entry.
VID This field displays the multicast VLAN ID.
Port This field displays the port number that belongs to the multicast group.
Multicast Group This field displays IP multicast group addresses.
To Next Page
Loading...
