1. Prepare dowel holes on a selected place and in a selected height using a drilling template shown on the
package. Cut a cable installation hole in the backplate.
TIP
Download the drilling template from 2N.com.
2. Pull the metal holder downwards on the device back side to remove it.
3. Put the cables in the backplate and put the backplate against the wall. If you connect the device to
installed cables, connect the wires.
WARNING
Insulate the wire joints with a shrink tube and glue to keep the cover rating as much as
possible.
4. Anchor the backplate to the base using screws and dowels. Screw the metal holder to the backplate.
5. Put the device on the backplate and insert the remaining cables carefully in the backplate.
6. Insert the device on the holder by pulling it from top to bottom making sure that the holder stops drive
under the screw heads on the device back side. When the device touches the holder carrying elements,
fix the device position by tightening the screw through the holder hole from the bottom.
Flush mounting
The flush mounting box allows you to place cables in the wall below 2N Access Unit M and mount the
device.
NOTE
Shortening the LAN cable in units Part No. 9161121, 9161141, 9161151 and 9161161 shall
not render the warranty null and void.
Installation
26
To Next Page
Loading...
