2N Access Unit M - RFID Card Readers

Tamper Switch
(part of the 2N Access Unit M main unit)
Inputs Can be used in passive or active mode (-30 V to +30 V DC)
• OFF = open or U
IN
> 1.5 V
• ON = short-circuited or U
IN
< 1.5 V
Standard RFID card reader Secured RFID card reader
Supported RFID cards 125 kHz:
• EM4x02
• NXP HiTag2
Supported RFID cards 125 kHz:
• EM4x02
• NXP HiTag2
• HID Prox
Supported RFID cards 13.56 MHz:
• ISO14443A (MIFARE Classic, MIFARE
Plus, MIFARE Mini, MIFARE Ultralight,
MIFARE DESFire CSN only)
• PicoPass (HID iClass CSN, Picopass)
• FeliCa (Standard, Lite)
• ST SR (SR, SRI, SRIX)
• Mobile Key
Maximum magnetic field strength at 10 m:
66 dBμA/m
Supported RFID cards 13.56 MHz:
• ISO14443A (MIFARE Classic, MIFARE Plus, MI-
FARE Mini, MIFARE Ultralight, MIFARE DESFire
CSN only)
• PicoPass (HID iClass CSN, Picopass)
• FeliCa (Standard, Lite)
• ST SR (SR, SRI, SRIX)
• HID PAC (HID SEOS, HID iClass SE, iClass SR,
HID MIFARE DESFire with SIO, HID MIFARE Clas-
sic with SIO)
• Mobile Key
• 2N PICard
Maximum magnetic field strength at 10 m: 60 dBμA/m
Bluetooth module
Bluetooth 5.0 in compliance with BLE (Bluetooth Low Energy)
RX sensitivity up to -94.8 dBm per 1 Mbps
Support of mobile applications Android 6.0 Marshmallow and higher, iOS 12.0 and higher
Technical Parameters
45