2N Indoor View - Page 27

2N® Indoor View User Manual
27 / 132
•
•
•
•
•
•
•
Static IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DHCP OFF):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Wait until the red LED goes off and the acoustic signal can be heard (approx. for
another 3 s).
Release the RESET button.
The following network parameters will be set after restart:
IP address:192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1
•
•
Note
The delay after pressing RESET till the first light and sound signalling is set to 15–
35 s depending on the 2N IP intercom/answering unit model used.
The time interval 18 sapplies to the 2N
®
Indoor View.
