2N Indoor View - Page 28

2N® Indoor View User Manual
28 / 132
•
•
•
•
•
•
Dynamic IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DCHP ON):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Wait until the red LED goes off and the acoustic signal can be heard (approx. for
another 3 s).
Wait until the green LED goes off and the red LED goes on again and the acoustic signal
can be heard (approx. for another 3 s).
Release the RESET button.
Factory Reset
Follow the instructions below to reset the factory default values:
Press and hold the RESET button.