Installation manual 2N® IP Solo
Surface mounting
concrete and steel structures, entry barrier columns, interior, etc.
What you need for mounting:
2N
®
IP Solo
We recommend you to use a mounting backplate, Part No. 9155068,
for uneven surfaces.
Glass mounting
glass surface
What you need for mounting:
2N
®
IP Solo, glass mounting backplate (Part No. 9155074)
•
•
•
Caution
The warranty does not apply to the product defects and failures arisen as a result
of improper mounting (in contradiction herewith). The manufacturer is neither
liable for damage caused by theft within an area that is accessible after the
attached electric lock is switched. The product is not designed as a burglar
protection device except when used in combination with a standard lock, which
has the security function.
When the proper mounting instructions are not met, water might get in and
destroy the electronics. It is because the communicator circuits are under
continuous voltage and water infiltration causes an electro-chemical reaction. The
manufacturer’s warranty shall be void for products damaged in this way!
Do not remove the plastic foil on the inner frame seal to avoid water infiltration
and electronic destruction.
To Next Page
Loading...
