2N IP Solo - System Reset and Restart; Factory Reset

Installation manual 2N® IP Solo
46 / 74
•
•
•
•
•
•
Factory Reset
Follow the instructions below toreset the factory default values:
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously and the acoustic signal can be
heard (approx. 15–35 s).
Wait until the red LED goes off andthe acoustic signal can be heard (approx. for
another 3 s).
Wait until the green LED goes off and the red LED goes on again andthe acoustic signal
can be heard (approx. for another 3 s).
Wait until the red LED goes off andthe acoustic signal can be heard (approx. for
another 3 s).
Release the RESET button.