2N IP Solo - Configuration and Cautions

Installation manual 2N® IP Solo
53 / 74
•
•
•
Configuration:
Connect the2N
®
IP Intercom Security Relayto the properly set intercom switch output;
refer totheConfiguration manual for 2N IP intercoms. Make sure that one LED at least
on the2N
®
IP intercomSecurity Relayis on or blinking.
Press and hold the2N
®
IP IntercomSecurity RelayReset button for 5 seconds to put the
devicein the programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent from
theintercom will be stored in the memory and considered valid. After code initialisation,
the2N
®
IP IntercomSecurity Relaywill pass into the operational mode (the green LED is
blinking).
•
Caution
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
2N
®
IP Intercom Security Relay using the instructions above.

•
Tip
FAQ: 2N
®
IP Intercom Security Relay – what is it and how to use it with 2N IP
intercom?
