Software Features 15
Software Features Mobility System Software (MSS) provides a combination of standard
wired LAN features and wireless LAN features that enable you to
integrate the switch into your wired network and provide network access
for wired or wireless users.
Management
Features
■ Serial and network command-line interface (CLI) access—You can
access the CLI through a direct serial connection or through the
network using Secure Shell (SSH) or Telnet.
■ 3Com Wireless Switch Manager management application—3Com
Wireless Switch Manager is an extensive GUI application for planning,
configuring, deploying, and managing a 3Com network and its users.
3Com Wireless Switch Manager uses Secure Sockets Layer protocol
(SSL) to interact with MSS.
Link
(WX1200 only)
Solid green 100-Mbps link is operational.
Solid amber 10-Mbps link is operational.
Blinking green Traffic is active on the 100-Mbps link.
Blinking amber Traffic is active on the 10-Mbps link.
MAP
(WX1200 only)
Solid green For a MAP access point’s active link, with
PoE enabled, all the following are true:
■ MAP access point has booted.
■ MAP access point has received a valid
configuration from the WX switch.
■ Management link with a MAP access
point is operational.
Alternating green
and amber
MAP access point is booting with an image
received from the WX switch.
If the LED remains in this state indefinitely,
the boot or configuration attempt has
failed.
Solid amber PoE is on but no MAP access point is
connected to the link.
Blinking amber MAP is not connected or is unresponsive,
or there is a PoE problem.
Unlit Port is not configured as a MAP access
port, or PoE is off.
Table 4 WX Status LEDs (continued)
LED Appearance Meaning
To Next Page
Loading...
