40 CHAPTER 3: CONFIGURING A WX SWITCH FOR BASIC SERVICE
additional 24 MAPs, up to 96 MAPs total. You can upgrade the WX4400
only. The WX1200 cannot be upgraded.
To display the current license level and install an upgrade license, use the
following commands:
display license
set license license-key activation-key
The license key is shipped with the switch. To obtain the activation key,
access the 3Com web site. Each license and activation key pair allows the
switch to actively manage an additional 24 MAPs. You can install up to
three upgrade license and activation key pairs, to actively manage up to
96 MAPs.
The following command installs an upgrade license:
WX4400# set license WXL-076E-93E9-62DA-54D8 WXA-3E04-4CC2-430D-B508
Serial Number : M8XE4IBB8DB10
License Number : 245
License Key : WXL-076E-93E9-62DA-54D8
Activation key : WXA-3E04-4CC2-430D-B508
Feature : 24 additional ports
Expires : Never
48 ports are enabled
success: license was installed
The additional ports refers to the number of additional MAPs the
WX4400 can boot and actively manage.
Configuring the
Time and Date
To set the system time and date:
1 Set the time zone to specify the offset from Coordinated Universal Time
(UTC).
2 Configure MSS to offset the time by an additional hour for daylight
savings time or similar summertime period, if applicable.
3 Specify the IP address of a Network Time Protocol (NTP) server or statically
set the time and date.
To Next Page
Loading...
