Installing a WX Switch 25
Protection Association (NFPA) 70, National Electrical Code (NEC) is
required. Consideration must be given to the electrical ratings on the WX
switch and branch circuit protection. Do not install equipment such that
the branch circuit current and voltage protection is exceeded. Pay
particular attention to the earthing connection for the supply
connections. When using an extension cord or power strip, pay attention
to the grounding type.
Equipment Rack
Installation
You can install a WX4400 switch into a front-mount or center-mount
equipment rack. You can install a WX1200 switch into a front-mount
equipment rack.
■ Figure 4 shows how to install a WX4400 switch into a front-mount
equipment rack. (Installation of a WX1200 switch is similar.)
■ Figure 5 shows how to install a WX4400 switch into a center-mount
equipment rack.
Refer to these figures as you perform the procedure.
To Next Page
Loading...
