Configuring IP Connectivity 45
WX1200# set ip route default 10.10.20.19 1
success: change accepted.
WX1200# display ip route
Router table for IPv4
Destination/Mask Proto Metric NH-Type Gateway VLAN:Interface
_________________ _______ ______ _______ _______________ _______________
0.0.0.0/ 0 Static 1 Router 10.10.20.19 vlan:4:ip
10.10.10.4/24 IP 0 Direct vlan:2:ip
10.10.10.4/32 IP 0 Local vlan:2:ip:10.10.10.4/2
10.10.10.255/32 IP 0 Local vlan:2:ip:10.10.10.4/2
10.10.20.2/24 IP 0 Direct vlan:4:ip
10.10.20.2/32 IP 0 Local vlan:4:ip:10.10.20.2/24
10.10.20.255/32 IP 0 Local vlan:4:ip:10.10.20.2/24
224.0.0.0/ 4 IP 0 Local MULTICAST
The 0.0.0.0 route is the default route. The 10.10.10.x and 10.10.20.x
routes in this example are automatically added by MSS when you
configure the corresponding IP interfaces. The 224.0.0.0 route is for
IGMP snooping. MSS automatically places this route in the configuration.
Verifying IP
Connectivity
To verify that the WX switch can send and receive IP traffic, use the
following command:
ping host
The ping command sends an Internet Control Message Protocol (ICMP)
echo packet to the specified device and listens for a reply packet. For
host, specify the IP address of a host device on the network.
If you configure the Domain Name Service (DNS) or set a local alias for
the host device, you can specify the DNS hostname or the alias instead of
the IP address of the device. (For information, see the Wireless LAN
Switch and Controller Configuration Guide.)
The following command verifies IP connectivity to IP address 10.10.20.19:
To Next Page
Loading...
