72 CHAPTER 3: CONFIGURING A WX SWITCH FOR BASIC SERVICE
Table 13 Defaults for Radio Profile Parameters
Parameter Default Value
Radio Behavior When Parameter Set To
Default Value
11g-only disable Allows associations with 802.11g and
802.11b clients.
This parameter applies only to 802.11b/g
radios.
beacon-interval 100 Waits 100 ms between beacons.
dtim-interval 1 Sends the delivery traffic indication map
(DTIM) after every beacon.
frag-threshold 2346 Transmits frames up to 2346 bytes long
without fragmentation.
long-retry 5 Sends a long unicast frame up to five times
without acknowledgment.
max-rx-lifetime 2000 Allows a received frame to stay in the buffer
for up to 2000 ms (2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled for
transmission to stay in the buffer for up to
2000 ms (2 seconds).
preamble-length short Advertises support for short 802.11b
preambles, accepts either short or long
802.11b preambles, and generates unicast
frames with the preamble length specified
by the client.
This parameter applies only to 802.11b/g
radios.
rts-threshold 2346 Transmits frames longer than 2346 bytes by
means of the
Request-to-Send/Clear-to-Send (RTS/CTS)
method.
service-profile No service
profiles defined
Default settings for all service profile
parameters, including encryption
parameters, are used.
short-retry 5 Sends a short unicast frame up to five times
without acknowledgment.
To Next Page
Loading...
