Displaying and Saving the Configuration 85
display config [area area] [all]
save config
The display config command without the all option displays only those
configuration changes that are different from the default settings of the
WX switch and its MAP access points. The all option displays the entire
configuration including the default values of all parameters.
The following command displays the beginning of the configuration file
on a WX switch configured with the commands in this chapter:
WX1200# display config
# Configuration nvgen'd at 2004-9-16 14:12:37
# Image 3.0.0
# Model WX1200
# Last change occurred at 2004-9-16 14:03:52
set ip route default 10.10.20.19 1
set system name WX1200
set system ip-address 10.10.10.4
set system countrycode US
set timezone pdt -8 0
set summertime PDT start first sun apr 4 0 end last sun oct 31 0
set service-profile corp1 ssid-name private_wlan
set service-profile corp1 ssid-type crypto
set radius server svr1 address 10.10.70.20 key rad1pword
set radius server svr2 address 10.10.70.40 key rad2pword
set server group grp1 members svr1 svr2
set server group grp1 load-balance enabled
set enablepass password b6b706525e1814394621eeb2a1c4d5803fcf
set authentication dot1x ssid private_wlan EXAMPLE\* pass-through grp1
set radio-profile rp1
set dap 1 serial-id M9DE48B012F00 model mp-262
set dap 2 serial-id M9DE48B123400 model mp-341
set port type ap 1,2,4 model ap2750 poe enable
set dap 1,2 radio 1 radio-profile rp1 mode enable
press any key to continue, q to quit.
WX1200# save config
Configuration saved to configuration.
To Next Page
Loading...
