498 CHAPTER 46: MBGP MULTICAST EXTENSION CONFIGURATION
Configuring the local address as the next hop when advertising routes
This involves removing the next hop configuration in the routing information
advertised to a peer (group) and configuring the local address as the next hop
address. It is valid only for IBGP peers/peer groups.
Please perform the following configurations in IPV4 multicast sub-address family
view.
Specifying the routing policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family
view.
By default, no routing policy is specified for any peer (group).
Configuring IP-ACL-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family
view.
By default, a peer (group) does not perform route filtering based on the IP ACL.
Configuring AS-path-list-based route filtering policy for a peer (group)
Please perform the following configurations in IPV4 multicast sub-address family
view.
Tabl e 489 Configure the local address as the next hop when advertising routes
Operation Command
Configure the local address as the next hop
when advertising routing information
peer group-name next-hop-local
Remove the above configuration undo peer group-name next-hop-local
Tabl e 490 Specify the routing policy for a peer (group)
Operation Command
Configure routing policy for incoming packets
peer { group-name | peer-address }
route-policy policy-name import
Remove incoming policy configuration
undo peer { group-name | peer-address }
route-policy policy-name import
Configure routing policy for outgoing packets
peer group-name route-policy policy-name
export
Remove outgoing policy configuration
undo peer group-name route-policy
policy-name export
Tabl e 491 Configure IP-ACL-based route filtering policy for a peer (group)
Operation Command
Configure filtering policy for incoming packets
peer { group-name | peer-address }
filter-policy acl-number import
Remove incoming policy configuration
undo peer { group-name | peer-address }
filter-policy acl-number import
Configure routing policy for outgoing packets
peer group-name filter-policy acl-number
export
Remove outgoing policy configuration
undo peer group-name filter-policy
acl-number export
To Next Page
Loading...
