3Com III - Installing the EISA Adapter

2
INSTALLING THE EISA
ADAPTER
This chapter describes how to install the 3C592 EISA adapter
in your computer. An overview of these procedures is shown
in Figure 2-1.
Figure 2-1 Hardware Installation Overview
After installing the adapter, you can load the network drivers,
as described in Chapter 4. If necessary, you can change the
software option default settings, as explained in Chapter 3.
1
Inspect the adapter.
2
Install the boot PROM.
(optional)
3
Insert the adapter.
4
Connect to the network.
5
Go to Chapter 3,
“Configuring the Adapter.”