Loading Drivers in Non-NetWare Environments 4-15
Loading Drivers in Non-NetWare Environments
To load drivers in a non-NetWare environment, follow these
steps:
1 Access the main menu as described in the section
“AutoLink Installation” earlier in this chapter.
2 Select Network Drivers in the main menu.
3 Select the appropriate driver for your network operating
system from the menu choices.
The menu program copies the selected driver to a specified
disk drive.
4 Refer to the on-line readme files on the 3C59X EtherDisk
diskette for information about working in other network
operating systems. Refer also to your network operating
system manuals for additional information.
NDIS Drivers
If you have loaded NDIS drivers in a computer with multiple
3Com adapters, you must specify the port address for each
adapter, as documented in the PROTOCOL.INI file on the
3C59X EtherDisk diskette. The file is located on the startup
diskette or the hard drive.
To install a second adapter when running Windows NT
, do
not change the PROTOCOL.INI file. Instead, repeat the
procedure used to install the first adapter.
The 3C59X EtherDisk diskette can be used as an OEM import
diskette for Windows for Workgroups or Windows NT.
The path to the OEM files should point to \NDIS\WFW or
\NDIS\WINNT35, respectively.
To Next Page
Loading...
