3Com III - Finding the Adapters Port Address for Multiple Adapters

4-12 CHAPTER 4: LOADING NETWORK DRIVERS
Finding the Adapter’s Port Address for Multiple
Adapters
To find the appropriate adapter’s port address when installing
more than one adapter in a NetWare server, follow these steps.
You must use the adapter’s port address when installing one
or more adapters in a server. You must use the adapter’s slot
number when installing one or more adapters in a client.
1 Access the main menu on the EtherDisk diskette.
a Boot the computer under DOS.
b Insert the EtherDisk diskette in a floppy drive and make
that drive the active one.
c At the prompt, type:
INSTALL [Enter]
The main menu appears.
2 Select Configuration/Diagnostic/Troubleshooting, and
press [Enter].
3 In the next screen, select Configuration and Diagnostic
Program, and press [Enter].
If multiple adapters have been installed, the screen that
appears will list them.
4 Select the adapter whose port address you want.
5 Select View in the menu bar, and press [Enter].
The screen that appears contains the desired I/O port
address. Make a note of the address.
6 Repeat steps 3 and 4 for each adapter.
7 Exit the program.