3Com III - 4-1 Overview of Loading Network Drivers4-1; Autolink Information Screen; Main Menu

4-6 CHAPTER 4: LOADING NETWORK DRIVERS
Figure 4-2 AutoLink Information Screen
Figure 4-3 Main Menu
ESC=Cancel
This option will install a complete DOS ODI client.
[ENTER]=Continue
[ESC]=Exit Program
3Com's auto installation software (AutoLink) automatically configures your
adapter and workstation for use as a NetWare client. To use AutoLink:
* Have only one 3Com Bus Master adapter installed
* Use NetWare v2.X, v3.1X, or v4.X as your network operating system
* Have DOS on the client being installed
AutoLink edits your AUTOEXEC.BAT and CONFIG.SYS files and saves the old
versions. Select General Information/Release Notes in the main menu for
information on AutoLink server support. To manually set up your adapter
or for information/drivers for other NOSs, use the options under Standard
Installation and Configuration in the main menu.
EtherDisk-3C59X Fast EtherLink/EtherLink III Bus Master Adapter Family v.X.X
(C) Copyright 1995, 3Com Corporation. All Rights Reserved
ESC=Cancel F1=Help
MAIN MENU
Program & information for configuring/testing/troubleshooting adapters
[ENTER]=Execute Function
[
↑↓ ]=Scroll
[F1]=Help [ESC]=<Cancel>
Auto Installation with Configuration (AutoLink)
NetWare DOS ODI Client
EtherDisk-3C59X Fast EtherLink/EtherLink III Bus Master Adapter Family v.X.X
(C) Copyright 1995, 3Com Corporation. All Rights Reserved
Standard Installation and Configuration
Network Drivers ...
Configuration/Diagnostic/Troubleshooting ...
General Information/Release Notes